Rear Bumper Sill Guard SKU: SKUMAC028

This is a thin, flimsy film that is very difficult to install. It is probably worth less than $10. I would reconsider this purchase unless you are going to a professional installer.

Were I to improve this part: 1. Some instructions. Steps to follow: 2. Clean paint surface well & remove entire decal from backing and then attach 1/2 on same backing lengthwise 3. Make sure fingers are clean 4. Place black dot above where notch would go (do not cover) 5. Air removal can be helped by heating with hand held hairdryer and make sure you have enough light to properly follow the proper line of placement. 6. carefully remove backing and reapply an inch farther down. 7. Follow earlier steps 8. Completely remove backing and repeat all steps and finish. The entire process would have been immeasurably easier had the backing been cut for section removal without going through a complete removal and partial reattachment to backing. Since this is simply a 3M pre-cut sticky decal, and yes I know that Porsche is printed on the box so it has to be more expensive than without, it really should cost far less than twenty dollars.

Rear bumper sill guard is almost invisible, and is perfect to protect the sill and top of rear bumper from "casual" scratches. Customer service at SunCoastParts.com was great.

good product you need to have some lube on hand so you can move it around ,before the final location is selected. don't purchase it if you are stupid !

Do NOT buy if you intend to install yourself. I waisted $59.95. Product comes with NO instruction, film is super tacky. Spend more and have a professional do it for you.