Side Marker Light Set - Macan SKU: 95BCLEAR

Looks fine but does not fit tightly to the original wiring plug. The back for the bulb mountIng hole material is thinner than the OEM light so the oring seal is loose and does not seal tight so I had to add a thicker oring in order for it to fit tight and secure.. Also, when you rotate the plug to snug it up, its not aligned properly to the assembly so had a hard time aligning it to the mounting holes to make sure it does not damage the bumper while installing. These are not very well made. I will be replacing them with higher quality LED to match the rear side markers. I would have expected a better product from Suncoast. Wasted $50.

Changed out the side markers on wife's 2018 Macan S, took me all of 5 minutes and she loves them, even through she did not think she needed them.....

Great DIY project for the weekend. It just took 15 mins to take out the stock marker lights and snap these on. I wish the bulbs were LEDs for a better night look.

Nice monochromatic look removing the orange replacing with the smoked.

I wish I could post a before and after picture. The final look is so much better than the amber lights, especially on a black Macan. Installation was easy and only took about 10 to 15 minutes. Ultimately, I do wish I had purchased the LED version since those look better at night than the bulbs.

The side markers practically disappear on a Jet Black Metallic Macan - looks fantastic! Quick turn around time as usual from Suncoast parts.

They do look great installed. The lit looks would be much improved if they were LED. A distinct row of LEDs would be much more pleasing than a glowing round bulb. My fault for not noticing they were incandescent before I purchased. Also the thickness of the back for the bulb mountIng is thinner to the point where they would not seal tight so I changed the o-ring to snug it up like the OEM fit. I’ll probably be replacing them with LED.

Stock Side markers were difficult to removed, but new replacement Lenses were easy to snap in and fitted perfectly,, wow,, what a difference!!!

I got the tinted ones and they are a perfect replacement to the UGLY Yellow OE ones. Easy install. Unscrew 3 torx screws to fold the inner mesh liner open. Push the spring clip in and the rear end of the light will pop out. Remove the bulb from the socket and push the wire on the new fixture in.

easy install: partially remove wheel well cover [dont even need to jack up car] with very short screw driver or philips bit in a ratchet. use a long screw driver to release the tab on old light and pull out. keep all wires on the car, just pull out the light bulb, and plug new light wire into light bulb socket. subtle change, but i really like the look on my white macan.