(New Jersey) | January 28th, 2022
This mount is exactly what I was looking for. Installation took about 10 minutes, and it works great. I would buy again. I don’t know if it is strong enough to hold up for track use, but it is fine for daily driving.
(CA) | October 8th, 2021
I was hesitant at first to purchase any enhancement that required a physical attachment - for no other reason than I like keeping the car as close to factory new as possible.
After watching the install video I decided to give it a shot and I am incredibly pleased. The installation was simple (less than 10 min) it works great - and I can remove it at any time without any damage or marking on the car. Love it.
(Hanford, CA) | September 24th, 2021
I purchased this phone mount for a 2015 Cayman S. I first tried installing it on the driver side but the phone blocked my view of critical buttons and functions on the screen. Moving it to the passenger side worked much better and nothing is obstructed from view if the phone is attached slightly away from the console. It’s still easily within reach and I can rest my wrist on the shift knob while operating the phone. The phone mount is very well made and worth the price in my opinion. The installation video was helpful in giving me the confidence to start pulling the moldings off without thinking I was going to break anything plastic.
(California) | February 5th, 2021
I put one on our 2015 Cayenne (right side vent mount) and then on my 2015 Boxter (right side console mount). Love that they look factory and are both minimalist and strong. Getting the vent out with 4 screwdrivers being leveraged to pull in the clips is a bit scary but take your time, watch the video and you can do it in the end. Install on Boxter is easier (removing / popping off trip versus having to push clips ) but both eminently doable. Make sure to tighten the silver ball with and Allen wrench before installing. One installed you would have to remove to tighten. Basically follow the directions and you will love it! Installed first on left vent of Cayman but moved to right so as not to block the radio screen (backup camera). Like it on the right side much better!
(Alabama) | January 4th, 2021
...a diagram of the backside of the console panel would have helped greatly., I certainly appreciate the installation video, but the panel was much harder to pull off then shown in the video and, like another reviewer, though I watched the video many times and planned exactly how and where I would pull to remove the panel, I still broke two tabs. I think that had the instructions included a diagram of the backside of the panel, I might have avoided breaking the tabs.
Once the panel is removed, installation is simple and the mount very solid. I was able to avoid blocking any part of both the PCM and the drink holder on my 991.1 by sticking the metal tab off-center on my phone. The magnet holds the phone securely and nothing blocked. Awesome! Also happy to say that the panel didn't really need the two tabs that broke. If I don't wiggle it, I can't tell that they're missing.
(CA) | November 19th, 2020
Reviews are pretty spot on. It is, indeed, a solid piece of hardware. If installed correctly (and that includes the magnetic strip - which does work on the back inside of a slim iPhone case), your phone will NOT go anywhere. I hear what "FLAWED" is saying, but I drive pretty hard according to the G Force meter in my car and I cannot imagine the phone coming off the mount.
I will reiterate Ryan's sage advice re: installation. If you aren't VERY careful, you'll break a tab. I watched the videos, read the instructions and proceeded with great caution. Still broke a tab when removing the first piece. No big deal as there are more tabs than necessary to keep the trim pieces secure. Just wiggle and pull up very gently and you'll be okay.
The mount works perfectly. I like it on the upper right side so I can use my cup holder and the phone is best in my line of sight. The only real downside is that the mount (with phone on it) obscures the far left of the PCM. So, you can't see your "SOURCE" button and a bit of the screen. No biggie and I'm not even deducting a star for it b/c this mount is so vastly superior to all other options.
TOP TIP: Route a long iPhone cable from the glove box through the right/passenger trim (make sure to leave enough slack to the glove box closes properly) and through/under the center console to the driver's side. If you use the farthest-forward hole, you'll end up with the cord exiting the driver's side in a place that is not visible to car occupants. With a little work, you can leave just enough slack under the console so that all you see is about 3" of cord coming from the driver's side trim directly to the bottom of your mounted phone. Super clean and easy to do! Can't believe it's not part of the instructions since it is soooo much better than having an iPhone cable coming from the glove box and flapping around on on top of the console. You're better than that! Escape mediocrity! Go for the pro routing!
(San Francisco, CA) | March 14th, 2020
This is a professional-looking, clean and solid piece of hardware with an absolutely excellent design. Installation was easy with the help of the video, and my side panel was tough to remove at first, but once I got it off, everything else was smooth. I would recommend placing the metal adhesive piece on the inside of your phone case as the magnet is super strong and can tear it off the outside if you remove quickly. I recommend mounting on the upper right position.
(Fairfield County, CT) | December 30th, 2018
Room for improvement...
(California) | September 8th, 2018
I had to use the included steel plate (glues to back of phone) to prevent my Galaxy S9 from flying off the mount in a hard turn. With the plate on the phone, inductive charging doesn't work. The threads inside the ball are extremely tight - I thought my allen wrench was going to break. Once installed, the unit looks very clean. I mounted it near the glove box so that I can run a very short length of charging cable out - again it looks clean.
(California) | April 3rd, 2018
Installation was easy and it works great (but be careful taking the console trim off your car - it's easy to break a tab if you don't know the right direction to pull.)